Select brands directly
1. Find out the brand code which is short for the brand
from table list
2. Press and hold “SEL” key, release it when the code
on LCD flashes.
3. Repeat press “BRAND +” or “-” key until the brand
code appears on LCD.
4. Press “OK” key, brand code stop flashing. Setting
finishes.
5. If it does not work well . please aim to the air condi-
tioner. press and hold “OK” key until air conditioner
sends “buzzer” sound. After setting, check other fun-
ction keys can work or not. if it works. setting succe-
ed, If not. repeat above steps until it can use for your
air conditioner.
Auto searching-1
1. Open air conditioner. put remote aim to NC. press and
hold “SEL” key until the brand code appears on LCD.
2. Press and release “SEL” until air conditioner send
“BUZZER” sound, after release key, the code flashes.
3. Press “OK” key, brand code stop
flaShing. Auto searching finishes.
Check all other functions whether can work or not. if
it does not work’ repeat above steps until it can use
for your equipment.
Auto searching-2
If you do not know the brand of your air conditioner, or if
your brand is not listed in the code table, please operate
as per following steps:
1. Open air conditioner, aim at NC, press and hold “OK”
key
2. Release “OK” key as quickly as air conditioner sends
“BUZZER” sound
3. Check all other functions whether can work or not, if
it does not work; repeat above steps until it can use
for your equipment.
Clock set up
1. Press the “CLOCK” button, it is blinking.
2. Press the “BRAND/TIME + or -” , setting to the cur-
rent time.
3. Press the “CLOCK “ button again, stop blinking, the
time setting is complete.
If you did not press the “CLOCK” button, it can be set-
ting automatically after 5 sec. time and clock signl. Now
swtting is complete.
TIMER OFF
You should set the timer off after open the air condi-
tioner.
1. Press the “TIMER off” button. the LeD displays the
clock signal and time blinking.
2. Press “BRAN or -” button, adjust to the re-
quired time
3. It will confirm the time of TIMER OFF after 5 seconds.
Setting finishes.
4.
Note:
1. The time frame can be set between 00-24 hours;
2. Press the “TIMER OFF “ two times continuously, can-
cels the timing .
3. If you want to see the timer off time, you only should
press “TIMER OFF” , Then It will show this time, and
after 5 seconds. it will show current time again.
4. After timing setting. the launch direction of remote
control must be aim at the receive direction of your
air conditioner in the effective distance, otherwise the
timing setting ineffectively.
Attention
1. If it is not used for a long time, remove the battery
to avoid leakage liquid of the battery to damage the
machine. When the LeO looks dim, please change
batteries. (New and old batteries can not be used to-
gether) After the batteries are replaced every time. it
is not necessary to set model code again.
2. Check carefully that there is no remora between re-
mote controller and Air conditioner when the time off
doesn ‘ t work. Because the operation is effective only
when the air conditioner receives the timer off signal
from remote controller.
3. The manufacturer keeps the right to change the pa-
rameter and function of product.
EN
