STARTING AND USE INSTRUCTIONS
ET 65-75
Rev. 000
20/12/04
23/34
4.7.6 SQUEEGEE ADJUSTMENT
The squeegee has to be well regulated in order to have a perfect dry system. This kind of squeegee can
perfectly suck water, which flows into the suction pipe, but it must be parallel to the surface.
The operator has to follow the instructions below for the squeegee adjustment:
¾
Remove the ignition key from the dashboard in order to avoid the casual starting of the machine.
¾
By means of the knob (see detail nr. 3 in picture nr. 4.11.) regulate the squeegee. The best squeegee
pressure is reached when the corner of its blade is in contact with the floor and their inclination is
between 45° and 60°.
¾
Squeegee pressure regulation: the operator has to work on the squeegee driving wheels cam pins .
The operator has to unloose the screw at the bottom of the pin by means of the spanner delivered
with the machine. Afterwards the operator has to tighten this screw again.
Make sure that the two wheels of the squeegee are well regulated in order to keeps both its
blades parallel to the floor.
1. Squeegee height regulation screw
2. Squeegee fastening screw
3. Squeegee inclination screw
2
3
1