INSTRUCTIONS FOR STARTING AND USE
I 16/18 NEW
Rev. 00
22/05/08
Pag. 23/36
4.7. FUNCTIONING
The scrubbing operation is too delicate being necessary, by experience, to value correctly the kind of brush
to be used, the necessity or not for a double scrubbing action, the better choice of the detergent. if floors are
too dirty, we recommend a double scrubbing action. During this first step the squeegee is up and brushes
are in operating position. Start up the brushes, for a first wiping, in a small area. The solution will be left on
the floor to dissolve dirt, performing its solvent function until it’s completely collected by the second wiping.
Of course this last one has to be done with the brushes down and the squeegee keeping contact with the
floor.
Scrubbing operation has to be executed by acting on the starting switch for brushes motor, pulling down the
brushes with the pedal, and actionning the lever of water regulation. Water dosage must wet all the surface.
A single scrubbing action involves to put down the squeegee, then switch on the driving lever. The squeegee
is put down by the lever. The suction motor will run by the interrupter. After the scrubbing and drying
operation, first turn off the water, then the brush interrupter ,raise the brush concluding the drying operation.
Finally the suction motor has to be switched off .
Before proceeding with any kind of operation, check out that protections are still firmly
fixed.
4.7.1 STARTING AND MACHINE PREPARATION
If the autoscrubber is connected to the system for charging the batteries is necessary to take off the charger
plug; make the water loading lifting up the carter (see also particular 1 in picture 4.7)
The machine can be now started up rotating the main ignition key. So let’s start the scrubbing operation
PICTURE N° 4.7
1
