Fiori E81 AQUA, User Manual

5

If the hood fails to operate correctly, briefly

disconnect it from the mains power supply for

almost 5 sec. by pulling out the plug. Then plug it

in again and try once more before contacting the

Technical Assistance Service.

Warning!

— The hood cannot be connected to flues of

other appliances that run on energy sources

other than electricity.

— When the hood is used at the same time of

other appliances that run on energy sources

other than electricity, provision must be made

for an adequate supply of air.

— No food must be cooked flambeé underneath

the hood.

The use of an unprotected flame is dangerous

for the filters and could cause fires.

Therefore, never use an open flame under the

hood. When frying foods, never leave the pan

alone because the cooking oil could flare up.

— Please, keep to the provisions of official

directives regarding the question of fume

discharge.

— The manufacturers refuse to accept any

responsibility for damage to the hood or its

catching on fire because of failure to observe

the above instructions.

Maintenance

Before performing any maintenance operation,

isolate the hood from the electrical supply by

switching off at the connector and removing the

connector fuse.

Or if the appliance has been connected through

a plug and socket, then the plug must be removed

from the socket.

Metal grease filter (2 or 3 pieces)

The metal grease filter lasts forever and must be

washed either by hand or in the dishwasher

(65°C)

 with suitable detergents.

The metal grease filters must be washed at least

once a month and anyhow whenever 

 LED 4

indicates the saturation of the filter.

This 

LED

  warns you when  the metal grease filter

needs to be cleaned.

This 

LED

 flashes to warn you that the metal

grease filters must be cleaned.

Generally, these  must  be cleaned after 40 hours

of use.

Once  the grease  filters  have  been  cleaned, press

button  1 for some seconds until you hear the

acoustic signal (beep): the 

LED 4

   will now stop

flashing.

When  washed in a dish washer, the grease filter

may discolor slightly, but this does not affect its

filtering capacity.

Remove the filter  

      using the handles designed

for this purpose by pulling the filter backwards

and then downwards (Fig. 1).

Let  the filter dry  without  damaging  it  before putting

it back into place.

Carry out the above steps in reverse order to put

the filters back after having washed them.

Carbon filter (2 pieces)

This filter dissolves cooking odors.

The carbon filter must never be washed.

The carbon filter should be replaced every 

4

months under normal use and anyhow  whenever

LED 5 

indicates the saturation of the filter.

This 

LED

 indicates carbon filter needs to be

replaced.

This led flashes to warn you  that  the  carbon  filter

must be replaced.

This must be done after approximately 160 hours

of use.
Once you have replaced the carbon filter, press

button 

1

 for about 3 seconds until you hear the

acoustic signal (beep).

The 

LED 5

   will now stop flashing.

Using the hood—

The hood  is  provided  with a  motor  with  severa l speeds.

For the best performance,we recommend using 

the low  speeds in normal conditions and the high 

speeds in  particular cases of strong odour and 

vapor concentration.—We recommend starting 

up the hood a few minutes  before  cooking and 

keeping  it   running  until all the odors have been  eliminated.