13
FIPA Spider vacuum traverse
Vacuum generation can now be switched off with the on/off switch.
6. MAINTENANCE
Warning! Only carry out maintenance if you have all the spare parts available.
The maintenance instructions must be followed precisely in order to ensure that the system works
safely and that the lifting characteristics are not impaired. If faults are detected in the system, these
must be rectified immediately before the FIPA Spider vacuum traverse can be started up again.
>
The device must be switched off during servicing and secured against being switched back on
again.
>
Only genuine FIPA spare parts are to be used for maintenance and repairs. Genuine FIPA spare
parts are matched to the necessary loads and forces of the vacuum traverse. Using other spare
parts can lead to serious defects and to the warranty being voided.
Maintenance of the vacuum pump
General information
>
Always disconnect the pump from the mains supply, so that it is not switched on unintentionally.
>
Do not carry out work on the pump if it is at an excessively high temperature (risk of burns).
>
The operating personnel must be technically trained to work with vacuum pumps.
All the applicable accident prevention regulations concerning the protection of the individual
must be complied with at all times.
>
Do not perform any work procedures not described in this manual.
