9 |
P a g e
Battery Replacement
Firecom Electronic Headsets use a
Lithium Ion battery. Firecom batteries are the
only batteries that have been tested and verified to operate correctly with the
Headset. Use only Firecom approved batteries (Firecom part #320-0015-00). Use of
batteries from other sources will void your warranty.
WARNING: Use only Sonetics approved batteries.
Tools Required: Sonetics Screwdriver (Flat Head Screwdriver)
1.
Pull back the right ruggedizer if the Headset has one installed.
2.
Open the battery door on the right dome using the screwdriver.
3.
Remove the battery, and recycle or discard per local laws. Refer to
Rechargeable Battery Information
4.
Insert the replacement battery, positive end first.
5.
Close the battery door and tighten the screw.
6.
Replace the ruggedizer if installed.
LED Indications
The Firecom Electronic Headset uses a multicolor LED indicator to give additional
information on the status of the Headset. The table below describes the behavior
while charging or in use (not all functions are available on all models).
Charging
Non-Charging
Function
Red Flash
Headset On
Blue Flash
Bluetooth
® Connection Established and in
progress
Red
/
Green
Headset in DECT pairing mode
Green Flash
DECT Connection Established and in
progress
Blue
/
Green
Both Bluetooth and DECT connections
Established and in progress
Flash
Led color will vary
Depending on
connection type
Battery Level
= Battery >75%
= Battery 50-75%
= Battery 25-50%
= Battery <25%
Red Solid
—————
Charging
Green Solid
—————
Fully Charged
Summary of Contents for FHW50X
Page 2: ......
