The Tool/Axe Loop can be installed on any available Gear Loop, although the recommended
installation is on the second Gear Loop from the fixed Attachment Point (D-Ring).
AXE - TOOL HOLDER
Start by opening the unit and then slip the
Plastic Separator from the BOTTOM of the
belt, and between the belt and the second
gear loop.
Fold the Reinforcement Flap over the belt and
gear loop.
Proceed by turning over the belt and, align
and fasten the Velcro Flap. The Axe/Tool
Holder is now installed.
back of belt view
front of belt view
front of belt view
Separator
Reinforcement Flap
Velcro Flap
Gear Loop
Start by setting the Top Adjusting Buckle to the
outside edge of the tool. Then pull the adjusting
strap to cinch the Main Buckle down to secure
the tool.
Top Adjusting Buckle
Use caution when donning/doffing your
belt with a tool in the Axe/Tool Holder.
Tool may fall and cause serious injury.
Main Buckle
This extension adds 12” to any of our escape belts. This accessory NFPA certified and it is made
with the same hardware and webbing as our belts.
NFPA 12” BELT EXTENSION
