Panel Operation
7.3.6.5 S
ERVICE
M
ENU
–
A
NALOG
–
L
OOP
This menu item allows several diagnostic functions to be performed on the loops themselves. Firstly you will be
prompted to enter a loop number. Then the screen will appear as follows:
Actions:
•
Use the
NEXT
buttons to move to the next loop.
•
Pressing the
OFF
button will turn device blinking
off on the selected loop. If device blinking is already
off, the button will toggle to
ON
.
•
Press the
AUOTPRG
button to Auto Program the
selected loop. This will add any new detectors and
modules placed on the loop.
•
Pressing the
TOGGLE
button will change the
loops polling mode. If the loop is in CLIP mode, the
button will toggle it to FlashScan mode. If the loop is
in FlashScan mode, the button will toggle it to CLIP
mode. The toggle button is only available on the
AFP-2800. AFP-2802 can only operate in CLIP
mode
MENU
•
Pressing the
MENU
button will return you to the
service menu.
Note:
Applicable to V4.xx and below firmware
If the panel is powered down all loops will initialise with led blinking on. Where required, led blinking needs to
be turned off manually after a power up; the panel will not save the state of led blink after a cold reboot.
7.3.6.6 S
ERVICE
M
ENU
–
A
NALOG
–
A
NALOG
This menu item allows you to set the Loop styles to either Open or Closed loops. The screen will appear as
follows:
Actions:
DAY MODE
20 JULY 2002 14:44:37
LOOP 1 is Open Loop
LOOP 2 is Closed Loop
LOOP 3 is Closed Loop
LOOP 4 is Closed Loop
LOOP 5 is Closed Loop
LOOP 6 is Closed Loop
LOOP 7 is Closed Loop
LOOP 8 is Closed Loop
LOOP 9 is Closed Loop
LOOP 10 is Closed Loop
SET LOOP STYLE FOR INSTALLED LCM/LEM
TOGGLE
AFP-2800/2802 Manual
– P/N DOC-01-011
69
DAY MODE
20 JULY 2002 14:44:37
LOOP 1 SELECTED:
LCM Version
-> 2.11
Loop wiring style
-> Open
Device led blink
-> ON
Detector Poll Style
-> FLASHSCAN
Module Poll Style
-> FLASHSCAN
Soft button functions:
ON/OFF
-> Turn device LED blink ON/OFF
AUTOPROG -> Look for new devices on loop
TOGGLE
-> Change the poll mode on loop
NEXT
OFF
AUTOPRG
TOGGLE
ANALOG MENU - LOOP
A = 0
F = 0
I = 0
N = 0
•
Use the
UP
/
DOWN
buttons to move to the next
loop.
•
Pressing the
TOGGLE
button will change the loop
style for the selected loop between Open and
Closed.
•
Pressing the
BACK
button will return you to the
previous menu.
DOW N
BACK
UP
ANALOG MENU - LOOPS
A = 0
F = 0
I = 0
N = 0
Summary of Contents for AFP-2800
Page 139: ...Appendix 9 12 PANEL EXPANSION RELAYS AFP 2800 2802 Manual P N DOC 01 011 139...
Page 156: ...Notes...
Page 157: ......
Page 158: ......
