Contact us for assistance: (866) 985-7877 | www.wtliving.com
8
ASSEMBLY
7
Install
Reflector
: Support and tilt the heater, or use a step-
stool to reach the top of the heater to slide the
Reflector
over the 3 studs that are pre-installed in the top of the
Head
Assembly
B
. Then place a
Washer
GG
over each stud and
secure using the 3
Wing Nuts
EE
. After tightening the
Wing
Nuts
, return the heater to an upright position.
Hardware Used:
3
x
EE Wing Nut
(M8)
3 x
GG Washer
(M8)
8
Connect the
LPG cylinder (Sold separately. Use a
standard 20 lb. propane cylinder only): Lift the
Tank
Housing
C
up and rest it on the top of the assembled
Post Supports
H
. Screw
Regulator
E
onto the end of
the
Gas Hose
D
. (Do not cross-thread.) Hand-tighten,
then tighten securely with a wrench. Place LPG tank
onto
Base
of heater, and secure LP tank in place by
hooking
Tank Strap
G
onto the
Post Supports
. Attach
Regulator
to valve on LPG tank. Lower the
Tank
Housing
.
NOTE: Use this heater only with a propane vapor
withdrawal supply system. See chapter 5 of the
ANSI/
NFPA 58 Liquefied Petroleum Gas Code
, Standard for
Storage and Handling of Liquefied Petroleum Gas.
Your local library or fire department should have this
book.
