background image

Contact us for assistance:  (866) 985-7877  |  www.wtliving.com 

                           

 

 

 

      3

SAFETY INFORMATION

 DANGER

CARBON MONOXIDE HAZARD

 This appliance can produce carbon 

monoxide which has no odor.

• 

Using it in an enclosed space can kill you.

• 

Never use this appliance in a enclosed 

space such as a camper, tent, car or 
home.

 WARNING

FOR OUTDOOR USE ONLY

• 

Cylinders to be used must be constructed 

and marked in accordance with US DOT

• 

Storage indoors is permissible only if the

  cylinder is removed. 

 The unit should be secured or moved 

indoors if winds exceed 19.5mph.

NOTE: Use only 20lb. LPG tank (not 

supplied). Use only CSA regulator with 
1.2m gas hose (included).

 WARNING

By-products of the combustion fuel used 
by this product contain chemical known 
to the State of California to cause cancer, 
birth defects or other reproductive harm.

 WARNING

• 

Improper installation, adjustment,

  alteration, services or maintenance can 

cause injury, death or property damage.

• 

Read the installation, operating and

  maintenance instructions thoroughly
  before installing or servicing this 

equipment.

 WARNING

 This appliance must only be used 

outdoors.

• 

Using this product in an enclosed area 

may cause injury, death or property 
damage.

• 

Read the instructions before use.

 This appliance must be installed in 

accordance with such regulations  
as are in force.

• Do not use

 the heater in an explosive 

atmosphere.

• 

Keep the heater away from areas where 

vapors are stored.

• 

Prior to use check for damaged parts such 

as hoses, regulators, pilot or burner.

 WARNING

 At least once a year, the unit should be 

inspected for the presence of spiders, 
spider webs or other insects.

• Check

 the heater immediately if any of the 

following exist:

1. The smell of gas in conjunction with 

extreme yellow colored tips of the burner 

2. The heater does not reach temperature.
3. The burner makes popping noises during 

use (a slight popping noises is normal 
when the burner is extinguished after 
using).

 The propane hose with regulator assembly 

shall be located out of pathways where 
people may trip over it or in areas where 
the hose may be subjected to accidental 
damage.

• Child

ren and adults should be aware of 

the hazards of high surface temperature 
and shall stay away to avoid clothing burn 
or ignition.

 Young children should be carefully 

supervised when they are in the area of 
the heater.

should not be hung from the heater, or 
placed on or near the heater.

 Any guard or other protective device 

removed for servicing the heater must be 
replaced prior to operation.

• 

Installation and repair should be done 

should be inspected before use and 
cleaning may be required at least once 
a year or as necessary. It is imperative 
that control compartment, burner and 
circulating air passageways of the heater 
be kept clean.

• 

Keep the appliance area clear of 

combustible materials such as gasoline 

and ventilation air.

• 

Keep the ventilation opening of the 

cylinder enclosure free and clear of 
debris.

 WARNING

 This appliance requires a gas hose and 

regulator.

 Regularly check the gas hose and if 

necessary, replace the gas hose.

 Disconnect LPG cylinder before moving 

the heater.

 Do not attempt to alter unit in any manner 

(Example: using the heater without the top 

 Do not shorten the burner post assembly.

 The appliance shall not be used in 

basements or below ground level.

 It must always be placed on a solid and 

level surface.

 Always ensure there is ample fresh air 

ventilation.

 For outdoor use ONLY.

 Maintain at least 50’’ top and side 

clearance to combustible materials and 
surfaces.

 Never replace or substitute the regulator 

with any regulator other than the factory 
suggested replacement.

 Do not clean the heater with cleaners that 

are combustible or corrosive.

 Do not paint radiant screen, control panel 

 Leak tests should be done with a soapy 

solution. NEVER USE AN OPEN FLAME TO 
CHECK FOR LEAKS.

 The LP Gas cylinder should be turned off 

when the heater is not in use.

Summary of Contents for PH03-S















Reviews: