Contact us for assistance: (866) 985-7877 | www.wtliving.com
8
11
Attach
Reflector Studs
to the top of the
Head
Assembly
by inserting 1
Reflector Stud
into the hole
on the top of the
Head Assembly
. Tighten stud securely. Repeat
with the other 2
Reflector Studs.
Hardware Used:
3x
Reflector Stud
12
Remove the 4 pre-assembled screws and lock washers
from the base of the
Head Assembly
and set aside.
Route the
Gas Hose
down into
Upper/lower Posts
/
and align the 4 small holes on the base of the
Head Assembly
with the 4 small holes in the top of the
Upper Post
.
[HINT: Control knob should be above decal on post.]
Insert
the 4 screws and lock washers that were set aside through the
aligned 4 holes and tighten securely with the
Wrench
.
ASSEMblY
11
12
12
12
