EN
9
It is not always possible to find an optimum
location for an alarm, for example, a small
caravan may not have suitable vertical
surfaces available. Nevertheless, when fitting
an alarm in such situations, the two most
important considerations when selecting an
appropriate location are:
•
Not mounting the alarm directly above a
source of heat or steam; and
•
Mounting the alarm at a distance of 1 – 3
m from the nearest edge of the potential
source.
HOW TO INSTALL
YOUR ALARM
NOTE:
This alarm should be installed by a
competent person who feels able to install it
according to the instructions.
Firstly write the installation date on your
detector in the area provided. We recommend
that your detector is installed on the wall.
To mount on a wall or ceiling:
Please ensure that you use the screws
provided, as they were chosen specifically
for use with this product. Use the template
provided for guidance on marking hole
positions. Drill holes into the wall. Insert
the plastic wall plugs. Screw in the screws.
Ensure screws are protruding from the wall by
3mm to allow detector to slot onto screws.
To place on a shelf:
The base of the detector has been designed
to allow it to stand freely on a shelf.
WARNING:
When placing on a shelf,
please adhere to the same positional
recommendations as described above.
BATTERY INSTALLATION /
REPLACEMENT
To activate your alarm you will need to
remove the battery cover, and pull the
disabling tab out of the product. If you need
to deactivate your alarm reinsert the tab or
remove the batteries.
a
If the detector is already wall or ceiling
mounted then unhook it from the mounting
screws.
b
Remove the battery cover located on the
back of the detector.
c
Replace the batteries with 2 x approved 1.5
volt AA size alkaline batteries (see page 14
for recommended batteries), making sure
the batteries are the correct way round. Use
of batteries other than those recommended
by Sprue Safety Products Ltd may have
a detrimental effect on the detector’s
operation. Replace the battery cover and
return the detector to its original position.
90mm
Drill hole spacing