16
POWER PACK ACTIVATION
See diagram opposite
a
Your detector comes complete with an integrated power
pack that will provide power for its entire operational life.
To activate the power pack you need to pull the disabling
tab (see image). This will in turn pull out the metal disabling
clip, which is attached to the end of the tab, from the
disabling socket which is situated on the underside of the
detector. Retain the disabling tab for future use by taping it
to page 35 of this manual
b
When the detector is activated the Power LED will begin to
flash green once every minute to indicate that the detector
is receiving power from the power pack and is fully
operational
c
Test the sounder, power pack and circuitry by pressing and
holding the centre of the Test/Reset button briefly to confirm
that the detector is operating properly. The sounder will
sound as soon as the button is pressed, and the Alarm LED
will illuminate red indicating that the sounder is working
and the power pack is providing power to the unit. This
test for the sounder, power pack and circuitry should be
performed on a weekly basis. This should be continued for
the lifetime of the product.
WARNING:
Prolonged exposure to the sounder in
close proximity to your ears may damage your hearing.