17
Heat Sensor
4 “beeps” with 1-second
interval.
Dislocation Alarm
The Sensor is removed
from the mounting
plate.
Return the Sensor on the mounting plate with the LED
facing the user.
Heat Sensor
Short “beeps” with a few
seconds’ interval.
...
Pre-Alarm
The Sensor alerts of
danger for 20 seconds
before disconnecting
the cooker.
If the alarm was triggered during normal cooking: press
the Sensor cover once while the pre-alarm sounds. The
alarm is turned off and the sensitivity adjusts slightly.
Heat Sensor
Many quick “beeps” followed
by a long very loud sound.
Switch-off Alarm
The cooker is switched
off.
Press the Sensor cover once to return the power to the
cooker. Make sure that the switches are set to “0” in
case of a fire hazard or if you leave the cooker.
Control Unit
Short “ring” with 5-second
intervals.
No power
The power to the cooker
has been cut off.
Make sure that the switches are set to “0” in case of
a fire hazard or if you leave the cooker. Wait until the
cooker has cooled down after the cooker has been dis-
connected or press the Sensor cover once to reconnect
the cooker. If the cooker cannot be switched back on,
see FAQ, question 9, page 23.
Control Unit
Continuous "rings".
No power
The cooker is too hot
for the power to be
turned back on.
Make sure that the switches are set to “0” in case of a
fire hazard or if you leave the hob. Wait until the cooker
has cooled down and the Control Unit emits a short
“ring” with 5-second intervals, as described in the sec-
tion above, or press the Sensor cover once to reconnect
the cooker. If the alarm does not stop, follow the instruc-
tions on page 23, FAQ question 9, and press again.
Control Unit
Short and long “ring” with
10-second intervals.
No power due to
Auto-diagnostics Alarm
The cooker has been
disconnected due to a
temporary fault (auto-
matic error diagnosis).
Make sure that the switches are set to “0” in case of
a fire hazard or if you leave the cooker. Wait until the
cooker has cooled down or press the Sensor cover
once to reconnect the cooker. If the cooker cannot be
switched back on, see FAQ, question 3, page 22.
Heat Sensor
One “beep” per minute.
Battery Alarm
The Sensor has a low
battery.
The Sensor battery has run out and the Sensor needs
to be replaced. Pressing once on the Sensor cover
delays the alarm for 12 hours. When the batteries
have been used up, the cooker can only be used for 5
minutes at a time (EN requirement).
Control Unit
One “ring” per minute.
Battery Alarm
The Sensor has a low
battery.
The Sensor battery has run out and the Sensor needs
to be replaced. Pressing once on the Sensor cover
delays the alarm for 12 hours. When the batteries
have been used up, the cooker can only be used for 5
minutes at a time (EN requirement).
Action in event of alarm
The cooker will automatically be ready for use after the Stove Guard has detected
that the hazardous situation is over, and all the switches are set to “0”.
See the alarm overview below for actions.
