19
Pairing of devices
Checking the Sensor’s
sensitivity setting
1. Remove the Sensor from the
mounting plate. (The Sensor
gives 4 “beeps” ( ) and
the cooker is switched off.)
2. Press and hold the Sensor
cover (approx. 10 sec.) until two
“beeps” ( ) are heard.
3. After a moment, the sensor
beeps to indicate the configured
sensitivity. Unadjusted sensor’s
sensitivity setting is level 8, and
when checking the level, the
sensor gives a set of “beeps” as
follows: 8 - 8 - 5 - 8. If the sen-
sitivity was adjusted to level 3,
the sensor would give “beeps”:
3 - 3 - 5 - 3.
Acknowledgement “beep” factory
setting (unadjusted Sensor):
8 + 8 + 5 + 8 “beeps”.
Reset the sensitivity to
the factory setting
1. Remove the Sensor from the
mounting plate. (The Sensor gives 4
“beeps” ( ) and the cooker
is switched off).
2. Insert the battery disconnec-
tion piece (B) into the hole on the
underside of the Sensor. Press the
disconnection piece and the cover
against each other and hold in for
about 5 seconds.
3. Release the hold. (The Sensor emits a “beep” ). Remove the battery
disconnection piece and store it for future use.
4. Press and hold the Sensor cover until you hear 3 separate “beeps”
( ).
5. Return the Sensor to its position.
The units are already paired at the factory. When
replacing the Heat Sensor or Control Unit, the devices
must be paired again.
Note!
The Heat Sensor must be
placed on the mounting plate
during pairing.
1. Check that the cooker is con-
nected to the power supply.
2. Press and hold the reset but-
ton on the Control Unit for 20
seconds (see picture). While
pressing, the Control Unit will
emit some clicks and buzzes.
The Control Unit is now ready
to be paired.
3. Press and hold the Heat
Sensor cover until the Sensor
emits a “beep” ( ) and a
red LED flashes. The Control
Unit makes a buzzing sound
and the Heat Sensor emits a
“beep” ( ).
4. After 5 seconds, the Heat
Sensor gives an alarm
(“beeps” and continuous
beeping). The Control Unit
and Sensor are now success-
fully paired.
5. Reset the test alarm by press-
ing once on the Sensor cover.
Check that the cooker can be
turned on. If the Sensor does
not respond or if the test
alarm cannot be reset, see
FAQ, page 22, points 5 and 6.
B
Reset
button
