12
DANGER:
Under no circumstances should this product
be immersed in water, or used in an area where water
may come into contact with the product.
OPERATION
1. Standby Mode, but not “learned in” to a network.
The amber (fault) LED will be illuminated.
2. Standby mode
The Strobe should be connected to the mains AC
supply with the Vibrating Pad connected, and placed
in a suitable position. The Green “power” LED on the
strobe will be permanently illuminated.
3. Alarm mode
Strobe – Flashing strobe and either smoke or CO red
(alarm) LED flashing - Alarm
Pad – Vibration warning
When a Wi-Safe smoke or carbon monoxide alarm goes
into “alarm” mode the RESPECTIVE red alarm LED will
illuminate, the Strobe will continuously flash and the
Vibrating Pad will continuously vibrate.
LIMITATIONS
NOTE:
This Strobe and Vibrating Pad is not compatible
with products from the original Wi-Safe product range.
• The Strobe and Vibrating Pad will not operate in
isolation, with non Wi-Safe 2 Alarms, or any alarms
made by other manufacturers.
• The separate units making up the Strobe and
Vibrating Pad cannot be interchanged with those of
other manufacturers and an attempt to do this may
render the whole system unsafe. Do not connect any
other product to the Strobe.
• The Strobe and Vibrating Pad may not respond to
the signal from a Wi-Safe 2 alarm if the alarm and the
Strobe containing the control box are too far apart
(see positioning).
• The Strobe and Vibrating Pad may not respond
to the signal from a Wi-Safe 2 alarm if there are
obstructions that significantly reduce the signal
(e.g.: steel reinforcement in concrete). Always test
the operation of the Strobe and Vibrating Pad with
all other alarms and units in the network after any
changes to the building structure or in the position
of large items of furniture.
