5
NOTE:
When power is first provided to the Strobe,
the amber LED and both red LEDs will flash twice and
the unit will ‘bleep’ three times; the amber LED will
then illuminate continuously to indicate that the unit
has not been “learned in” to any network. Both alarm
LED’s (smoke and CO) will extinguish. This will typically
happen when the battery is connected. If the battery
does not retain any residual charge, it will happen when
the mains power is connected.
2. Remove the battery cover on the back of the Strobe
by pulling back the clip to release. Connect the
rechargeable battery, by aligning the terminals
(red wire to red wire) and clipping the connectors
together. You may hear the Strobe chirp as you do
this.
7. Plug the mains adaptor into a 230V socket and
turn the power on. The green power LED should
illuminate.
6. Plug the power cable in to the Strobe. Route the
wire through the wire guide (fig3).
3. Place the battery into the recess. NB: the battery
cable needs to be positioned underneath the
battery. Place the cable at the bottom of the recess
with the battery lying over the top with the text
on the battery face down. This will ensure that the
battery is installed correctly.
5. Assemble the power cable and adaptor by
positioning the plug head as shown. Rotate onto the
adaptor clockwise until it clicks into position. (fig2)
4. Replace the battery cover.
CAUTION:
Connect the battery with mains
power disconnected.
fig2
fig3
