INSTALLATION 5
1a
15cm
Zone 2
Zone 1
Radius 15 cm
Min 10 cm
Min 5 cm for
LED lamp
Zone 1 is immediately
above the middle of the
cooker plates. Max 15 cm
from the centre.
Zone
1
COOKER HOOD
Measure the installation height. The Heat Sensor should
be centred above the cooker, preferably within Zone 1
(see diagram at bottom of the page). It can be attached
to the grease filter. It is also important to ensure the
minimum distance from any lights underneath the hood
is 10 cm (5 cm is enough for LED lamp).
Please note: Zone 1 is recommended for best
performance.
1
Measure distance
SELECTING THE MOUNTING LOCATION
I
f there is a metal mesh grease filter on the cooker hood,
make sure it is free of grease and dry.
Carefully remove the protective film from the installation
plate. Press for at least a minute while attaching installation
plate to allow adhesive to work.
2
MOUNTING THE INSTALLATION PLATE
Allow the Heat Sensor to reach room temperature before use.
The power to the cooker must be switched off (at the consumer unit).
See table on page 6 for the mounting location and follow instructions 1–4.
