FIG. 9
REV 9/8/09 Page 7
Glass can be used with the media or glass without other media. The design and amount of media to be used is up to the individual user.
IMPORTANT: Media should be placed naturally and NOT packed in tight. Loose fitting is important.
Media should never be placed under the spark guard that protects the sparking and flame rectification probes.
Take the remote control and push the ON button and you will hear the sparking start. Please note of this is the first time, this might
•
take two or three times for the burner to ignite. Air and gas might be in the line for installation, and all air has to be removed. The
direct spark will only spark 15 seconds before locking out.
Operator will have to turn the system off by pressing the OFF button on the remote, and wait one minute and start again.
•
If the system will not light the main burner in three (3) tries, the system should be investigated (see trouble shooting section).
•
Once the burner ignites turn the system off and start to place the “media” within the FPB to completely fill the bowl. Cover the
•
burner completely with media, and do not make the depth greater than 1’’ (one inch) over the burner ports.
FIG. 10
Once the Learn button is located, Press and release the Learn button once. You will hear a beep indicating that the module is
•
ready to receive a transmitter code.
The take the transmitter and press the OFF button. You will hear a series of beeps indicating that the new code has been accepted
•
by the module.
Reinstall the module to the side wall of the value box and replace the cover with all 4 screws.
•
LEARNING THE REMOTE CONTROL TO THE MODULE
The Firegear Fire Pit Bowl System is unique that it comes standard with one remote controlled transmitter.
•
All handheld remote’s are shipped with this system are already learned to the module.
•
Additional transmitters can be learned to this electronic module, up to a total of three transmitters. Contact Firegear offices to
•
discuss additional transmitter options.
Matching new transmitters is simple, but will require pressing the learn button on the module.
•
You should learn all transmitters before the installation of the FPB System into the fire pit.
•
Remove 4 screws holding
the cover on the value box.
Remove the module that is
attached to the value box. Find
“learn” button outside of the
module.
Fig. 11
Fig. 12
