REV. A Page 16
Burning Spur Round and Square Fire Pits with TPSI System
This fire pit instruction provides an option to mount the TPSI face plate to concrete board.
Use the template above to complete the installation.
The TPSI face plate can be mounted vertically or horizontally. Our suggestion is to attach
the face plate in a horizontal position with the gas valve on the left side. This allows the
control knob text to be orientated in a position to be easily read.
Using scissors carefully cutout the template and trace it on your concrete board. The
dotted line provides the cutout area to mount face plate. Use a concrete drill bit to drill (4)
3/16” diameter holes. Install the 1¼” black oxide screws through the front of the faceplate
with the nuts and washers on the backside. These are all provided in the hardware bag.
Note:
Mounting plate can also be installed into a paver control panel (PAVER-CP-MT)
bracket system.
CAUTION
: Careful not to over-tighten screws and nuts to ensure the cement board does
not crack or break.
Optional Cutout Template for
TMS Face Plate
7/8” Washer
Brass Nut
OASNG#
(Burner Orifice)
U3-8D-S
(Fitting)
Expanded View of
Thermocouple Manual (TMS) Safety Fire Pit
T200-9898-46
(Flex Connector)
Note: Use joint compound or Teflon
tape resistant to all gasses on all
male NPT threads; not flared fittings.
Ensure all connections are tight and
check for gas leaks before and after
assembly is complete.
Manual Gas Valve
(ST3-080-1009)
Mounting Nut
Thermocouple
Inlet
Gas Supply
Male Threads: Requires
Compound or Tape
(No compound/tape on
flared fittings)
U1-8C-S
(Fitting not supplied:
½
”
Flare
to 3/8” Male Thread Fitting)
U1-8C-S
(
Fitting)
Spur Burner
Fire Pit Pan
Knob
