INSTALLING MEDIA
I
nstall media into the burner pan. Ensure the media is lava rock, large broken glass or lava stones for proper operation.
Be sure media is free of any excessive dust. This prevents the burner pan weep holes from being plugged and holding
water. Loose fitting media is important to ensure robust flames.
Completely cover the burner with media but do not make the depth greater than 1-inch overtop of the burner port holes.
IMPORTANT: Do not place media under the screen cover. It must be free of any debris to operate properly.
PILO
T CO
VER
PILO
T SH
IELD
SCREEN COVER - 2 PIECES
INSTALLING PILOT COVER AND PILOT SHIELD
Final preparations will require you to install the pilot cover and pilot shield. They are wrapped in a protective material to
prevent scratches and are inside the carton of the fire pit.
After you fire tested the fire pit unwrap the pilot cover and pilot shield. The pilot cover will sit into place inside each
end of the cradle. The pilot shield then slides into the slots of the pilot cover and becomes a heat shield when the pilot
is burning for TFS models.
NOTE:
If you do not have a TFS system the pilot cover and pilot shield are required to be
installed on a MT model for a finished look.
Fig. 12 Installation of pilot cover and pilot shield.
Ensure the stainless steel screen is covering the burner as shown.
TFS Linear Fire Pits
REV. 4-13-16 Page 9