REV. 8-9-19 Page 11
AWS Sanctuary 2 & 3 Fire Features
Concrete Tab
Fig.
10
Installing burner assembly into the bowl.
IMPORTANT
:
Do not place rock over top or under the
screen cover.
The screen must be free of any debris to
ensure proper lighting of burner (See Fig. 12).
Cover the burner completely with media but do not make
the depth greater than 1-inch overtop of the burner
port holes.
Do NOT cover the top of mesh pilot hood with any rock or
glass. It must be free an any debris to operate properly.
Mesh Pilot Hood
Media
Fig. 12
Media placement around pilot hood.
MEDIA PREPARATION
MEDIA SPECIFICATIONS
The Sanctuary 2 and 3 models are approved for use with
Firegear Outdoor lava rock.
• Sanctuary 2 uses 57 LBS of Firegear Outdoor lava rock
• Sanctuary 3 uses 24 LBS of Firegear Outdoor lava rock
Lava rock height should be level and no higher than the top
lip of the bowl (approximately 2“ depth from burner pan).
Fig. 11
MedIa (lava rock) installation.
Attach another flex line to the top fitting and connect the
other end to the flared fitting of the gas valve box.
Securely tighten all fittings. Install the assembled pan into
the bowl as shown in Fig. 10 resting the pan on the
concrete tabs, centered, inside the bowl.
INSTALLING PAN INTO BOWL & WIRING
INSTALLATION OF MEDIA INTO BURNER PAN
Install lava rock into the burner pan. Ensure the lava rock is
a minimum of 1-inch diameter for proper operation.
Note:
Do not pour Lava Rock directly from bag. It should
be placed naturally and NOT packed in tight. Loose fitting
is important to ensure robust flames. Be sure rocks are
free of any excessive dust. This prevents the burner pan
weep holes from being plugged and holding water.
