REV. 8-9-19 Page 13
AWS Sanctuary 2 & 3 Fire Features
CAUTION
: Children and adults should be alerted to the hazards on high surface temperatures and should stay away to
avoid burns or clothing ignition. Young children should be carefully supervised when they are in the area of the appliance.
WARNING:
Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of control system and any gas control, which has been under water.
AWS OPERATION
SAFETY WARNINGS
1. Never leave the fire pit unattended during operation.
2. Clothing or other flammable materials should not be placed on or near the appliance.
3. Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the
appliance.
4. Installation and repair should be done by a qualified service person. The appliance should be inspected before
use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It
is imperative the control compartment, burners and circulating air passageways of the appliance be kept clean.
5. Inspect the fuel supply connection before each use of the appliance.
6. Temporary storage of this appliance indoors is permissible only if it has been disconnected from its fuel supply
(Natural or LP gas line).
WARNING
1. This appliance is hot when operated and can cause severe burns if contacted.
2. Do not burn any solid fuels in this appliance.
READ ALL LIGHTING INSTRUCTIONS BEFORE ATTEMPTING TO LIGHT FIRE PIT
CAUTION
:
ENSURE YOU HAVE LEAK TESTED THE FIRE PIT BEFORE OPERATING AND THE TRANSMITTER AND
RECEIVER HAVE BEEN “LEARNED”(PROGRAMED TOGETHER) FOR WIRELESS OPERATION.
WARNING: Do not stand overtop of fire feature during ignition or operation due to high surface temperatures.
LIGHTING INSTRUCTIONS
TURNING ON FIRE FEATURE
Prior to turning the fire feature ON, visually inspect the fire pit to ensure debris such as leaves or other combustible
materials have not collected on top of the fire feature, which could burn and emit embers once the fire feature is turned
ON. At the same time, ensure anyone standing close to the fire feature is aware you are turning it ON and steps away, at
a safe distance prior to lighting.
The ignition sequence is as follows:
1. Turn the manual key valve to the ON position.
2.
Turn the fire feature ON by pressing the ON button of the remote control. The hot surface ignitor will heat up and
begin to “glow” within a 10 second period.
3. Once the hot surface ignitor heats up, the pilot gas valve opens, a “click” is heard, and gas is released to the burner,
lighting the fire feature.
The entire ignition sequence ignites within 20 seconds or less. If not, press the OFF button on the remote control and
wait 5 minutes before trying again.
TURNING OFF FIRE FEATURE
1.
Turn the fire feature OFF by pressing the OFF button on the remote control.
2.
If you are no longer burning the fire feature until another time, we recommend turning the key valve to OFF position.
