Round Flat Disc
REV. 1-7-19 Page 25
Optional Cutout Template for
TMSI Face Plate
This fire pit instruction provides an option to mount the TMSI face plate to concrete board. Use the template
above to complete the installation.
The TMSI face plate can be mounted vertically or horizontally. Our suggestion is to attach the face plate in a
horizontal position with the gas valve on the left side. This allows the control knob text to be orientated in a
position to be easily read.
Using scissors carefully cutout the template and trace it on your concrete board. The dotted line provides the
cutout area to mount face plate. Use a concrete drill bit to drill (4) 3/16” diameter holes. Install the 1¼” black
oxide screws through the front of the faceplate with the nuts and washers on the backside. These are all
provided in the hardware bag.
CAUTION
: Careful not to over-tighten screws and nuts to ensure the cement board does not crack or break.