REV. 8-30-18 Page 10
Linear Outdoor Fire (LOF)
CAUTION
: Children and adults should be alerted to the hazards on high surface temperatures and should stay away to
avoid burns or clothing ignition. Young children should be carefully supervised when they are in the area of the appliance.
WARNING:
Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of control system and any gas control, which has been under water.
OPERATION
SAFETY WARNINGS
1. Never leave the Linear Outdoor Fire unattended during operation.
2. Clothing or other flammable materials should not be placed on or near the appliance.
3. Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the
appliance.
4. Installation and repair should be done by a qualified service person. The appliance should be inspected before
use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It
is imperative the control compartment, burners and circulating air passageways of the appliance be kept clean.
5. Inspect the fuel supply connection before each use of the appliance.
6. Temporary storage of this appliance indoors is permissible only if it has been disconnected from its fuel supply
(Natural or L.P. gas line).
WARNING
1. This appliance is hot when operated and can cause sever burns if contacted.
2. Do not burn any solid fuels in this appliance.
CAUTION
: Ensure you have leak tested the Linear Outdoor Fire before operating.
1. Insert key into gas valve.
2. Push and hold the red button on the manual Piezo ignitor and ensure sparking is occurring at the probes inside the
Linear Outdoor Fire (LOF).
3. Rotate the key counter-clockwise in gas valve to allow gas to flow.
4. Gas should ignite within 10 seconds or less. If Linear Outdoor Fire does not light within 10 seconds turn key clock-
wise to turn OFF the gas supply.
MANUAL SPARK IGNITION LIGHTING INSTRUCTIONS
MATCH THROW LIGHTING INSTRUCTIONS
CAUTION
: Ensure you have leak tested the Linear Outdoor Fire before operating.
1. Insert key into gas valve.
2. Light a long match or butane lighter and hold it near the burner.
3. Rotate the key counter-clockwise in gas valve to allow gas to flow and simultaneously apply the burning match as
close to burner as possible to light the Linear Outdoor Fire.
4. Gas should ignite within 10 seconds or less. If Linear Outdoor Fire does not light within 10 seconds turn key clock-
wise to turn OFF the gas supply. Ensure there is not too much media on top of burner that might inhibit gas flow and
try again.
READ ALL LIGHTING INSTRUCTIONS BEFORE ATTEMPTING TO LIGHT
READ ALL LIGHTING INSTRUCTIONS BEFORE ATTEMPTING TO LIGHT
