REV. 8-30-18 Page 9
Linear Outdoor Fire (LOF)
Unscrew (counter-clockwise) the Piezo ignitor module red button cap and the plastic mounting nut. Slide the module
on the back side of the module cover plate and secure with the plastic mounting nut. Insert the positive end of (1) AAA
battery into the ignitor module and carefully screw the red button cap to the ignitor module until snug. Careful not to
over-tighten the cap. Attach the extension wires (PIEZO23WH/25WH) to the 2-probe spark ignitor. Careful not to
overtighten the cap. Test the ignitor by pushing and holding the red button to ensure the ignitor probes inside the Linear
Outdoor Fire are sparking. The spark should be located directly overtop of the burner port hole for proper ignition of the
gas (See fig.8). Spacing between the probes should be approximately
⅛”
for proper spark.
IGNITOR ALIGNMENT (Manual Spark Ignition only)
For proper ignition it is important that the ignitor probes
be properly aligned overtop of the burner port holes.
Use the Fig.8 as a guide. Before lighting remove the
screen cover of the ignition hood to burner and ensure
the spark probes are directly overtop of a burner port
hole. The sparking probes must be in the path of a
flame to ignite the gas for proper ignition of the flame.
Replace the screen cover and follow the operating
instructions.
INSTALLATION OF LAVA ROCK/MEDIA INTO BURNER PAN
Install lava rock/media into the burner pan. Ensure the media is a minimum of 1-inch diameter for proper operation.
Note:
Do not pour Lava Rock directly from bag. Media should be placed naturally and NOT packed in tight. Loose fitting
is important to ensure robust flames. Be sure rocks are free of any excessive dust. This prevents the burner pan weep
holes from being plugged and holding water.
IMPORTANT
: Do not place media over top or under the screen cover. The
screen must be free of any debris to ensure proper lighting of burner and good flame rectification (See fig. 8).
Cover the burner completely with media but do not make the depth greater than 1-inch overtop of the burner portholes.
Decorative glass may be loosely scattered on top of the lava rock. Do NOT cover the stainless steel screen cover with
any rock or glass. It must be free an any debris to operate properly.
INSTALLATION OF BATTERY INTO PIEZO IGNITOR
(Manual Spark Ignition only)
+
-
AAA
Fig. 6
Piezo ignitor cap removal
Fig. 7
Piezo ignitor battery installation
Max. 1/8”
Gap
Fig. 8
Proper probe location
