Firegear LOF-30MTN, Installation And Operating Instructions Manual

REV. 2-4-19 Page 13

Linear Outdoor Fire (LOF)

MAINTENANCE 

1.  The Linear Outdoor Fire should be inspected and cleaned before initial use annually by a qualified field service per-

son.

2.  Any component that is found faulty must be replaced with an approved component.

3.  Any tampering or modifying with the Linear Outdoor Fire is dangerous and voids all warranties.

4.  During winter months in cold climates and various seasons operation the Linear Outdoor Fire may be affected by 

weather conditions.  It is recommended to use a ventilated cover overtop of your Linear Outdoor Fire to protect it from 

humid/rainy weather conditions when not in use.  Heavy rains/downpours could affect the Linear Outdoor Fire opera-

tion if not covered; if this occurs ensure you allow the Linear Outdoor Fire time to dry out before attempting to operate.  

NOTE

: If a combustible type cover is used over the Linear Outdoor Fire when not in use be sure to remove it before 

operation to prevent a severe safety hazard.

5.  Carbon (soot) may build up on the surface of logs (if installed) during heavy use.  Sooting may also occur periodically   

 on the screen of the ignitor hood.  To clean, brush off with a dry bristle brush or cloth.  Keep soot away from clothing 

of furniture.  

6.  Over time stainless steel parts discolor when heated, usually a golden or brown hue.  This discoloration is normal and   

 does not affect the performance of the appliance.

TROUBLE SHOOTING

Symptom

Remedy

Unit Won’t Light  

1. Ensure key valve is fully open.

2. Bleed gas line.

3. Ensure all gas supply lines are turned ON.

4. Ensure there is not too much media overtop of burner; it can inhibit gas from flowing.

5. Ensue E-Stop if turned ON (if applicable).

Low Flame 

1. Ensure the media is at least 1-inch in diameter and top media is no more than 1-inch over

    top of burner.

2. Adjust air shutter at bottom of Linear Outdoor Fire pit pan.

3. Ensure all shut-off valves and key valve is fully open.  See page 11; Fig. 7.

Water in Fire Pit  

1. Excess dust/sand material from media may be blocking the weep holes to relieve water.          

                 Remove all media and unplug weep holes.  Clean or install new media free of dust and dirt.

2. Ensure Linear Outdoor Fire pit enclosure has proper drainage for water and proper ventilation    

    to dry out.