MediaVault Hd SpecificationS
Model MVHd-250:
Includes one 250 GB hard
drive
Model MVHd-500:
Includes two 250 GB hard
drives (500 GB total)
interior dimensions (HxWxd):
5 7/8” x 6 1/4” x
8 7/8”
exterior dimensions (HxWxd):
10 1/2” x 11 5/8”
x 17 1/2”
Weight:
55 lbs
fire Rating:
UL
®
Class-125 1-Hour
HaRd dRiVe SpecificationS
3
Model:
Seagate Momentus 5400.4, 250 GB, SATA-
300
dimensions (HxWxd):
0.374” x 2.75” x 3.957”
Weight:
0.225 lbs
form factor:
2.5”
capacity:
250GB
interface:
Serial ATA-300 with USB “Mini-B” Enclo-
sure Interface
Spindle Speed:
5400 RPM
Buffer:
8 MB
Recording:
Perpendicular Recording
internal drive transfer Rate:
300 MBps
external drive transfer Rate:
58 MBps
Seek time:
<12 ms (average)
average latency:
5.6 ms
Max. ambient non-operating temperature:
158°F
3
Hard drives are PC & Macintosh compatible; one
installed in MVHD-250; two installed in MVHD-500.
ul claSS 125 fiRe Rating
Leading manufacturers clearly state the maximum
temperature for external hard drives should not
exceed 158°F. FireKing’s MediaVault HD is the
only product of its kind to be put through and
pass the Underwriters’ Laboratories Class 125 fire
test which requires exposing the MediaVault HD
to 1700°F for one hour. The internal temperature
may not exceed 125°F—well below the manufac-
turer’s maximum recommended temperature of
158°F, and relative humidity may not exceed 80%
during the test.
fcc coMpliance
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna. 2) Increase
the separation between the equipment and receiver. 3)
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. 4) Consult
the dealer or an experienced radio/TV technician for
help.
caution:
Do not make changes or modifications to
the equipment Unless otherwise specified in the manual.
Changes or modifications not expressly approved by
the party responsible for FCC compliance could void the
authority to operate this equipment.
