Option 1 Expert
Solder directly to the ESC. Make 2
slits on the sides of the ESC and
fold back the heat shrink to ex-
pose the 3 solder pads.
NOTE: Use caution when solder-
ing next to FETS.
Option 2 Intermediate
Splice ESC and motor wires
together as shown in the photo.
Only cut the wires from the ESC,
do not cut the motor wires. Cover
exposed solder joints with heat
shrink (not included).
Add top plate and feed the VTX
cable through the frame.
If you choose to add the optional
buzzer it should be installed at this
point.
In this step we will use the 2-1/2”
wires that you cut from the VTX
power cable earlier.
Solder these wires from the 5V on
the PDB to the flight controller.
10
