No HCT mount option
Locate the carbon fiber top plate.
Install four M3 10mm standoffs as
shown in photo to left. Install the
standoffs with M3 6mm screws
from the bottom side of frame.
Locate the 90 degree header pins.
Solder in place to channels 1-4 on
the flight controller. These are the
4 speed control connections.
NOTE: Double check polarity
marked on the flight controller for
your ESC’s
Satellite Receiver Option
Leave yourself 3” of wire to the
satellite receiver. Solder the three
leads to the flight controller.
External Receiver Option
Locate the wire loom and header
pins as shown in photo to right.
Solder header pins to flight con
-
troller
6
