www.charltonandjenrick.co.uk
9
LT6498 (ISS 2)
REMOVING GLASS PANEL
Remove the Gas Control Knob by removing the two retaining screws on the rear of the knob, it may be
necessary to turn the knob to gain access to the screws (Isolate Gas supply for safety).
Remove the Allen screw that fastens the door back to the stove and open.
Loosen the two lower screws on the lower glass fixing clamp, but do not remove clamp.
Remove the top glass fixing clamp secured with two screws, take care to support the glass panel when
removing the fixing clamp. Lift the glass out of the bottom clamp.
The glass should be place in a safe place to prevent damage.
Once the fuel bed has been re laid, reassemble in reverse order.
SECTION FOUR Fuel Bed Cleaning and Layout (Users Instructions)
Warning: -
Before you clean any part of the appliance ensures that the appliance is turned off and cold.
Use only the fuel bed components provided and no additional parts must added.
Incorrect positioning of the fuel bed components could result in the staining of the glass panel.
Important: - Refer to the ‘Health & Safety Notice located on page 5 of this booklet before cleaning or replacing any
refractory material.
The fuel bed components are delicate and they should be handled with great care.
The loose Log shapes may be removed for cleaning. They can be brushed very gently with a soft brush to
remove dust or any deposits.
A vacuum cleaner may only be used after the loose Log shapes and vermiculite has been removed.
CARE SHOULD BE TAKEN TO AVOID DAMAGE TO THE LOG SHAPES AS THESE ARE A DELICATE SURFACE AND SHOULD
NOT BE WIPED OR RUBBED.
It is important that all the Log Fuel Bed shapes are positioned as shown in these instructions.
Log Fuel Bed Quantities.
Six Log Shapes :-
Two rear Log shapes with cutouts at the back of the shapes.
Four main Log shapes.
Bag of Bark Chips & Bag of Vermiculite.
Summary of Contents for FPW
Page 28: ...28 LT6498 ISS 2 ...
