The BTA activators are installed on the end caps, which in turn are screwed on to the
aluminium tube prior to delivery, as shown in Figure 1 below.
Figure 1
The BTA activators are fully enclosed and protected inside aluminium housing during delivery.
This packing can accommodate up to two activators.
The activators for the cylindrical generators, have the activator adaptor installed on the main
body of the activator.
Figure 2
Aluminium Housing: Using a flat head screwdriver or a coin, please proceed to rotate anti-
clockwise the 2 caps, in order to unscrew them from the main tube and reveal the activators.
Figure 3
Once the end caps are unscrewed, proceed to unscrew the activators from the end caps by
hand, in an anti-clockwise direction.
Once the activators are unpacked, proceed with the installation of the activators on to the
upper mechanical parts (packed separately).
Activator
Activator
Act Adaptor
Unscrew using a flat
headed screwdriver or
a coin
