Contact us for assistance: (866) 985-7877 | www.wtliving.com
13
OPERATING INSTRUCTIONS
WARNING
FOR YOUR SAFETY
Heater will be hot after use. Handle with
extreme care. Reflector is hot to the touch.
OPERATION CHECKlIST:
For a safe and pleasurable heating experience, perform this check
before each use:
BEFORE OPERATING:
I am familiar with entire owner’s manual and understand all
precautions noted.
All components are properly assembled, intact and operable.
No alterations have been made.
All gas connections are secure and do not leak.
Wind velocity is below 10 mph.
Heater is for use outdoors (outside any enclosure).
There is adequate fresh air ventilation.
Heater is away from gasoline or other flammable liquids or vapors.
Heater is away from windows, air intake openings, sprinklers and
other water sources.
Heater is at least 91.44 cm / 36 in on top and at least
91.44 cm / 36 in
on sides from combustible materials.
Heater is on a hard and level surface.
There are no signs of spider or insect nests in heater orifices.
All burner passages are clear.
All air circulation passages are clear.
Clothing or other protective material should not be hung from the
heater, or placed on or near the heater.
Any guard or other protective device removed for servicing the heater
must be replaced prior to operating the heater.
Installation and repair should be done by a qualified service person.
The heater should be inspected before each use and at least annually
by a qualified service person.
OPERATION INFORMATION AND SAFETY:
• Unit will operate at reduced efficiency below 4.44° C / 40° F.
• Children and adults should be alerted to the hazards of high
surface
temperatures and should stay away to avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the
area of the heater.
• More frequent cleaning may be required as necessary. It is
imperative
that control compartment burner and circulating air passageways of the
heater be kept clean and free of debris and/or spider or insect nests.
SHUT DOWN:
1. Turn control knob
clockwise to OFF while
depressing the knob.
(Normally, burner will
make a slight popping
noise when extinguished).
2. Turn cylinder valve
clockwise to OFF and
disconnect regulator
when heater is not in use.
NOTE:
After use, some
discoloration of the
emitter screen is normal.
AFTER OPERATION:
1. Gas control knob is in
OFF position.
2. Gas tank valve is OFF.
3. Disconnect gas line.
4. Heater is stored upright
in a secure location.
