11
© 2020 Carrier
8. SPARE PARTS, WARRANTY CONDITIONS
8.1
Igniter operation-consumable parts and suggested spare parts quantity:
- Rod Tip, 685mm long
P/N
HE-TIP-24-L
- one for 4 igniters
- HV transformer 230/115VAC/1150VAC
P/N
HE-TR-1150
- one for 8 igniters
- Spark gap
P/N
HE-SG-24
- one for 8 igniters
- Capacitor, 3600 VDC/10μF
P/N
HE-CAP-10
- one for 8 igniters
- Capacitor, 3000 VDC/2μF
P/N
HE-CAP-2
- one for 8 igniters
- Capacitor, 3750 VDC/0.47μF
P/N
HE-CAP-05
- one for 8 igniters
- HV cable, with connector, 5 m long
P/N
HEC-24-5
- one for 8 igniters
Complete list of igniter spare parts Part Numbers is in Table 3
.
8.2
HDHESI construction includes two wearing parts:
- Rod Tip, long P/N
HE-TIP-24-L
- lifetime 1,000,000 sparks
- Spark gap P/N
HE-SG-24
- lifetime 200,000 sparks
ATTENTION:
Above lifetime refers to laboratory test conditions.
In the real combustion chamber environment, these values are lower. In the case of the rod tip: work in high
temperature conditions, corrosive properties of fuel, impacts and mechanical damages and in the case of oil
fuel ignition oil residues and slag on the tip after its withdrawal (possible burning out), impacts on the slag -
can significantly reduce the tip's life.
In the case of the spark gap lifetime it is influenced by the high temperature, the power supply stability and
the mode of operation of the igniter.
8.3
The warranty (see page 16) does not apply to spark gap P/N HE-SG-24 and ignition rod tip P/N HE-
TIP-24-L as the life time of these parts depend on the quantity of ignition cycles and the conditions
they have to work under.
Each rod tip and spark tube has one month warranty to be checked on receipt or within 1 month, for damage
and tested for the proper functioning. Fireye should be notified of any failure. After 1 month, the warranty
on tip expires.
8.4
This guarantee covers delivered devices and materials under conditions of proper installation, start-
up, operation and maintenance, it means the use in accordance with applicable instructions and
manuals.
This is particularly applicable to overheated parts i.e. working above their maximum operating
temperature defined in Instruction Manual.
8.5
The defective device or part will be replaced or repaired at manufacturer’s option.
The warranty applies to and may be executed only on a failed device send to the manufacturer warehouse for
examination or warranty repair.
8.6
The manufacturer does not accept liability for damage to persons or property resulting from:
–
mechanical damages, overheating,
–
improper installation, operation, maintenance of igniter contrary to the instructions in the user manual,
–
unauthorized igniter modifications or repairs made by unauthorized personnel,
–
use of components or spare parts other than original.
8.7
During the guarantee period any repairs or parts replacements must be carried out by the manufacturer service
department, or the user, upon the service's notification and consent.
8.8
Replacement of the consumables can be user-performed only after expiration of the guarantee.
NOTICE
:
BEFORE THE GUARANTEE PERIOD EXPIRATION ANY REPAIRS OR
PART REPLACEMENT MAY ONLY BE CARRIED OUT BY AN AUTHORIZED
MANUFACTURER SERVICE.
AFTER WARRANTY SERVICE CAN BE CARRIED OUT ONLY BY QUALIFIED AND
COMPETENT PERSONS AUTHORISED BY THE PLANT MANAGEMENT OR AN
AUTHORIZED MANUFACTURER SERVICE.
