English Customer Service: 1-844-FIRMAN1
09
FEATURES AND CONTROLS
Control Panel
NOTICE
Total power drawn from all receptacles must not exceed the name plate rating.
1.
Engine Start Switch
– To start engine, press and hold the switch in the START (ll) position, the
engine will crank and attempt to start. When the engine starts, release the switch to the RUN (l) position.
4.
3-1 Data-Minder (Multi-Meter)
– Push the SELECT button to show the Voltage, Hertz and running hours.
1
2
3
4
5 6 7
8
9
10
11
12
13
14
15
16
17
19
18
2.
Economy Control Switch -
The Economy Control switch can be activated in order to minimize
fuel consumption and noise while operating the unit during times of reduced electrical output,
allowing the engine speed to idle during periods of non-use. The engine speed returns to normal
when an electrical load is connected. When the economy switch is off, the engine runs at normal
speed continuously.
3.
AC Reset Button
– When the inverter is protected, the output can be restored by this button.
7.
Output Ready Indicator Light
– Remains “ON” during normal operating conditions. Shuts “OFF”
when generator is overloaded. The green AC Power Indicator Light comes on when the engine
starts and generates power.
6
.
Overload Indicator Light
– This light turns “ON”
when the generator is overloaded and will cut
power to the receptacles. If the engine overload indicator light comes on, the generator’s wattage /
amperage capacity has been exceeded by connected electrical devices or by a power surge. When
this occurs, the green AC Power Indicator Light will go off. The engine will continue to run,
but the red Engine Overload Indicator Light will stay on and power will no longer be supplied
to connected electronic devices.
5.
Oil Warning Indicator Light –
Check oil level when
this light turns “ON”. Engine will not run when
indicator is lit. When the oil falls below the minimum level, the oil warning indicator light comes
on and the engine stops automatically. The engine will not start until the proper amount of oil is
in the crank case.
8.
DC Circuit Breaker –
The DC
receptacles are protected by
an DC
circuit protector. If the DC output
is overloaded or an external short circuit occurs the circuit protector will trip.
9.
DC 12V Output -
8.3 Amps of DC current may be drawn from this receptacle. Use this outlet to charge
12V automotive type batteries ONLY. See 12V DC outlet (Battery Charger) section.
20
Summary of Contents for WH03662OF
