2
Opening Your Safe For The First Time
OPENING YOUR SAFE FOR THE FIRST TIME
BATTERIES AND EMERGENCY OVERRIDE KEYS
Remove three (3) AA batteries and two (2) Emergency Override Keys. They are
located in the protective foam insert at the top of the box.
1
Insert the key into the lock on the top of the safe.
2
Turn the key clockwise until the door opens.
3
Locate the battery compartment on the roof of the safe. Remove the shelf to
access the battery compartment.
4
Push the tab with your thumb to release the cover.
5
Install three (3) AA batteries. Make sure the batteries are installed in the proper
direction as indicated in the battery compartment.
6
Once the power connects, the light will blink red and green three (3) times.
7
Line up the rear tabs with the slots in the battery compartment and snap the
cover in place.
NOTE: WHEN THE BATTERY IS LOW, THE LIGHT WILL BLINK YELLOW WITH THE
PRESS OF A BUTTON. REPLACE WITH NEW AA BATTERIES IMMEDIATELY.
TESTING THE PASSCODE
1
Enter the factory pre-set code as follows: 1-2-3-4. The red light will blink with
each press of a button.
2
After properly entering the entire sequence, the green light will turn on for 2
seconds and the door will open.
3
Close the door to lock the safe.
NOTE: TURN THE KEY COUNTERCLOCKWISE TO REMOVE THE KEY FROM THE LOCK.
