3
Programming A Personal Passcode
PROGRAMMING A PERSONAL PASSCODE
1
Press the reset button located on
the right-hand side of the battery
compartment. The red light will blink
continuously. The red light is located
next to the reset button.
2
Enter your new 4 to 8 digit passcode and
press the reset button. The green light
will blink continuously. The green light is
located next to the reset button.
3
Reenter the set passcode and press
the reset button.
4
If both entries match, the green light will turn on for 2
seconds and a new passcode is set for operation.
5
If both entries do not match, the red light will turn on for
2 seconds and revert back to the previous passcode for
operation.
6
Record your new passcode in the Safe Identification Record on page 5.
SECURITY LOCKOUT PERIODS
a
If an invalid passcode has been entered, the LED light will flash
red and the safe will automatically lock out for 4 minutes.
a
If you forget your personal passcode, access to the safe can be
made using the emergency override key.
!
IMPORTANT
ONCE YOUR PERSONAL PASSCODE IS PROGRAMMED, THE
FACTORY PRE-SET CODE WILL NO LONGER OPEN THE SAFE.
4
MINUTES
