OM/SM-TDB/7(CE)
9
A simple turn of the thermostat controls the Groen
TBD/7 Kettle
Initial Start-Up
IMPORTANT:
BE SURE ALL OPERATORS READ, UNDERSTAND AND FOLLOW THE OPERATING
INSTRUCTIONS, CAUTIONS, AND SAFETY INSTRUCTIONS CONTAINED IN THIS MANUAL.
Now that the kettle has been installed, you should
test it to ensure that the unit is operating correctly.
1.
Remove all literature and packing materials
from inside and outside of the unit.
2.
Confirm that the kettle tilts properly. Either
turn the crank or use the handle to tilt the
kettle and return it to the upright position.
2.
Turn on the electrical service to the unit.
3.
Pour two to four liters of water into the kettle.
4.
Following “To Start Kettle” instructions in the
“Operation” section of this manual, begin
heating the water at the highest thermostat
setting. The heating indicator light should
come on immediately, and heating should
continue until the water boils.
WARNING
AVOID ALL DIRECT CONTACT WITH HOT
SURFACES. DIRECT SKIN CONTACT
COULD RESULT IN SEVERE BURNS.
AVOID ALL DIRECT CONTACT WITH HOT
FOOD OR WATER IN THE KETTLE.
DIRECT CONTACT COULD RESULT IN
SEVERE BURNS.
5.
To shut down the unit, turn the thermostat dial to
“OFF”.
If the unit functions as described above, it is ready
for use. If the unit does not function as intended,
contact your local Groen Certified Service Agency.
