2
Before starting
The FD-30 has a hard-wired power and signal cable with a female
mini-DIN connector. Connection to a PC or a First Data FD terminal
*
requires an adapter cable with a male mini-DIN connector at one
end and a USB connector at the other.
For Ingenico or VeriFone terminal connection, an adapter cable
with a male mini-DIN connector at one end and an Ingenico or
VeriFone PIN Pad port connector at the other is required.
Input rating: 5V/400mA(USB) or 12V/200mA(RJ12 offset)
Operating Temperature: 0°C ~ 40°C
Connecting device
To connect the PIN Pad to a PC or First Data FD terminal
*
:
First, plug the adapter cable’s mini-DIN connector into the mini-DIN
port of the FD-30 cable until a “click” sound is heard. Then plug
the USB connector into a USB port on the PC or at the rear of the
terminal.
To connect the PIN Pad to an Ingenico or VeriFone terminal:
Plug the mini-DIN connector of the adapter cable into the mini-DIN
port of the FD-30 cable until a “click” sound is heard. Then plug the
other connector into the designated PIN Pad port on the terminal.
Note: Turn off or unplug the terminal/PC whenever you connect or disconnect the PIN
Pad. Be sure the terminal/PC is not processing data when powering down.
Getting ready
The unit automatically starts up when connected to the PC/terminal.
The FD-30 device displays the message READY FOR SALE. The ready
message indicates the device is ready for use.
Using the reader
For contactless reader: Aim the center position of the card to the
contactless logo, and watch the LEDs for read status. A green light
represents a good read.
For magnetic stripe reader: Find the card reader slot on top of the
PIN Pad. User can swipe magnetic card in both directions, left to
right or right to left.
*
including the FD50, FD50
Ti
, FD100, FD100
Ti
, FD200, FD200
Ti
, FD300 and FD300
Ti
.
