© 2011 First Data Corporation. All Rights Reserved.
FD-SUG-FD30-0111
FCC INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Maintenance
Stringent quality-control standards are followed in manufacturing all
PIN Pad devices. Each unit receives numerous tests before leaving
the factory to ensure quality and reliability.
Note: Do not try to service, repair or adjust the PIN Pad device in any other way; doing so
will void your warranty.
Caution: Risk of explosion if the battery is replaced by an incorrect type. Please dispose
of the used battery according to local regulations.
Returning the PIN Pad
If you need to return your PIN Pad device for service or replacement,
contact your service provider or sales representative for instructions.
Caution: Use only shielded signal cables to connect I/O devices to this equipment.
Changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
