15
Tank Filling and Water Treatment
Procedures
Note: 17 liters of water is required
for maximum filling.
1. Remove Rubber Fill Plug from the top of the tank.
2. Place a large bucket of water next to the rower and position siphon with the rigid
hose in the bucket and the flexible hose into the tank as shown. Note: Make sure
small breather valve on the top of the siphon is closed before filling.
Note: Where water quality is known to be poor, FDF recommends the use of distilled
water.
3. Begin filling tank by squeezing siphon. Use Level Gauge Decal on side of tank to
measure volume of water in tank. Important: Do not overfill tank!
4. After filling tank to the desired water level, open the valve on the top of the siphon
to allow excess water to escape.
5. Ensure that Tank Plug is replaced once filling and water treatment procedures are
complete.
Tips on Siphon use: Putting the fill bucket higher than the tank will allow the siphon to
"self-pump" when adding water to the tank.
Water Treatment Procedures:
Add One Water Treatment Tablet.
Note: The amount of water treatment can vary widely depending on the Rower’s
location and exposure to sunlight. DO NOT, UNDER AN CIRCUMSTANCES USE ANY
TREATMENT TABLETS OTHER THAN THOSE SUPPLIED WITH YOUR ROWER. Your
rower box contents include 4x Water Treatment Tablets, which is sufficient for several
years of water treatment. Treat when water becomes discolored or shows signs of
Algae/Bacterial growth. To purchase additional Water Treatment Tablets, please consult
your nearest regional dealer/distributor or check our website at
www.firstdegreefitness.com
Tank Plug
Siphon
Fill tank
with
adjuster
handle set
to “MAX”
only.
Caution:
Use a drop cloth under the tank when filling the tank to avoid
staining floor or carpet.
Tank Filling and Water Treatment
Summary of Contents for DAYTONA AR
Page 1: ...PACIFIC AR NEWPORT AR DAYTONA AR USER GUIDE...
Page 27: ...27 Product Exploded Diagram...
Page 28: ...28 Product Exploded Diagram...
Page 29: ...29 Product Exploded Diagram...