16
Tip:
Correct bungee tension is achieved when enough recoil is present for the Rowing
Handle to easily reach the front of the Rower Pulley Belt Bracket at the far front of the
frame. If the Rowing Handle will not reach rearward to the end of the Seat Rail, the
Bungee Cord is over-tightened and will require adjustment.
Replacing the Bungee Shock Cord:
Reinstall the Shock Cord through the Upper Frame, along the opposite side of Idle Wheel, through
the Mid Frame and Lower Bungee Pulleys and then tie off with plastic tie wrap to correct tension.
Replace Frame Plug.
Bungee
Shock Cord
Bungee Attachment Point
Pull Bungee
through un-
til seated
securely
Removing the Bungee Shock Cord:
First, move the Rowing Handle to it’s farthest
forward point on the Mainframe, then cut the
plastic end tie and follow the drawing above
for bungee removal. Next, remove the Upper
Frame Plug to allow the Bungee Shock Cord
to be threaded through the top of the frame.
Note: You will need to rotate the Belt/Bungee
Pulley to align the holes properly. Should the
belt drop off of during the bungee change,
please refer to the previous pages for
“Attaching/Reattaching the Rower Belt”.
Bungee
Shock Cord
Bungee Attachment Point
Upper Frame Plug
In areas where tap water quality is known to be
poor, FDF recommends the use of distilled water.
Once Bungee Cord and Upper Frame Hole are aligned, push
the Bungee Cord up and through the frame as shown
Upper Frame
Hole
Belt/ Bungee
Pulley
