4
Location Considerations
The proper location to install the water softener and filter system will ensure optimum performance and
satisfactory water quality. The following factors should be considered in selecting the location of the
equipment.
1. The water softener and filter system should be installed after the water meter on municipal
water. Operating pressure of the softener must be limited to within 30
– 100 psi range.
2. The water softener and filter system should be installed as close as possible (preferably
within 15’) to an adequate floor or laundry drain capable of handling the backwash cycle
volume and flow rate (refer to unit specifications).
3. All water conditioning equipment should be installed prior to the water heater. Water
temperatures exceeding 100°F can damage the internal components of the control valve and
filter tank. Install with at least 10’ of pipe before the water heater to prevent thermal damage
to the equipment. An expansion tank may need to be installed in the line to the water heater
in order to allow for thermal expansion and comply with local plumbing codes.
4. The water softener and filter system should not be subject to freezing temperatures.
5. Ensure that any cartridge or in-line type filter installed prior to the water softener and filter
system does not restrict the water flow and pressure available for backwash and interfere
with normal operation.
Pre-installation Instructions (cont.)
