© 2011 Belwith
®
Products, LLC. | All Rights Reserved | www.firstwatchsecurity.com | # SRG717
© 2011 Belwith
®
Products, LLC. | All Rights Reserved | www.firstwatchsecurity.com | 72291 Rev B
11
11
2.2 Install the SecuRemote™ Status Monitor
1. Remove the Location Marker Cover. With the garage door in the closed position, install the
Location Marker on the top of the garage door. Replace the Location Marker Cover.
2. Remove the Location Sensor Cover. Install the Location Sensor on the garage wall within 2” of
the Location Marker (c). Replace the Location Sensor Cover.
3. Tack the two white wires to the wall with the supplied wire staples.
4. Operate the door from close to open to close again.
5. The blue light on the SecuRemote™ device will flash for a few seconds, indicating you have
correctly installed the Status Monitor.
Location Marker Cover
Location Marker
* Location Marker Buffer
Screw
Top of Door
Wire Staple
White Wires
Location Sensor
Location Sensor
Cover
Screw
Top of Door
2”
Inside of Garage Door
Collision
Risk
Best Mount
Out of Range
Door
Location
Marker
Location
Sensor
(c)
Step 1
Step 2
1.
1.
1.
2.
2.
*
2.
2.
3.
* Location Marker Buffer is only
required when mounting on a
steel door.
