By Firstech, LLC 18
19 By Firstech, LLC
Advanced System Functions
This remote has the ability to operate a 2
nd
vehicle. Hold buttons for 2.5 seconds to activate this feature. The remote’s LEDs will flash
confirming that 2
nd
car mode is activated. The remote will remain in 2
nd
Car Mode until you hold the buttons for 2.5 seconds again.
The remote will beep twice and the LEDs change from red to amber to confirm 2nd car mode is off.
IMPORTANT: 2
nd
car mode requires the remote to be programmed to a 2
nd
vehicle that is equipped with the same remote kit.
R
c@m @Hm @v @cI
Advanced System Functions
The RPS is an optional feature. Basic RPS and car call functions do not require programming, however in order for the sensor to unlock/disarm the
vehicle you must perform the following procedures;
STEP 1: Disarm/unlock the alarm (remote must be programmed first) and choose a 4 digit code. You can not have zeros.
STEP 2: Turn ignition key to the “on” position and leave the driver’s door open.
STEP 3: Knock on the windshield in front of the RPS a total of 5 times (each time you knock the LED on the RPS will flash RED). The LED will begin to
flash rapidly in BLUE with successful completion of this step.
STEP 4: Enter the first digit of the desired four digit pass code by knocking on the windshield in front of the RPS the desired number of times. For
example, to enter 3, knock on the sensor 3 times (each time you knock the LED will flash RED) then wait.
STEP 5: The LED on the RPS will confirm your first number by flashing BLUE slowly. Once the LED begins to flash rapidly in BLUE, enter your second
number by repeating step 4.
STEP 6: Repeat steps 4 & 5 to enter all four numbers.
STEP 7: Turn the ignition OFF - the RPS disarm/unlock feature is now programmed. Follow steps 3 - 5 to enter your disarm/unlock code.
STEP 8: (Optional) If you would like to rearm/relock your vehicle then close all doors, knock on the RPS 5 times and your vehicle will lock/arm.
rps@Hr @p@s I@u@O@d
