ISSUE 3 | MAy 2019 | PAGE 3 OF 4
4.
MOUNTING
Choose a vertical surface near approved ground but away from down spouts, permanent water
sprinklers, and other water sources.
To wall-mount the unit, select #8 wood screws (and washers, if needed behind screw head), or
hardware appropriate for the wall surface
.
Figure 2
— Mount the Unit
5.
GROUND THE UNIT
Step 1:
Open cover.
Step 2:
Pierce grommet and feed #6 AWG ground wire into the unit. Ground to the ground
stud or optional ground lug.
Figure 3 — Grounding and Feeder Cable Installation
Wall-mount
Conduit-mount
TPA-3690
Use cable tie or
large hose clamp.
#8 Wood screw,
add washer if needed.
Ground Wire
Feeder Cable
Open cover
using can wrench
Strain-relief Clamp x 2
Use spacers to prevent
crushing cable
