HEF2 Series MANUAL
107
17. START-UP RECOMMENDATIONS
IMPORTANT
Request start-up of your units by contacting:
https://
fisair.com/es/servicio/puestas-en-marcha/ (application in Spanish)
https://
fisair.com/service/start-ups/ (application in English)
The operation of the FISAIR HEF2 Series evaporative humidifier is mainly determined by the irrigation of the
evaporative panels. The humidifier will work as such whenever there is a current of air passing through it and
the water pump irrigates the panels.
[Remark 1. Recirculated water systems]:
Before starting the air fans, to remove inorganic dust
from the panel surfaces, for the purpose of preventing air flow contamination and avoid extra foam
formation, it is recommended to repeat the following cycle for 6 periods: 10 min of pump operation
(recirculating the water) and then, 10 min of emptying.
[Remark 2: Direct water equipment]:
Before starting the air fans, to remove inorganic dust from
the panel surfaces, for the purpose of preventing air flow contamination and avoid extra foam
formation, direct water irrigation of Cassettes is recommended during 60 min without air flow, to wash
the panels.
[Remark 3]:
To avoid leaks, double check that all links/threads are well fixed and adjusted at the
commissioning. Teflon gaskets, Teflon tape or special glue for threads should be used in the cases
where they are needed.
[Remark 4]:
Double check water basins mandatory levelling. This is a very important point because
a fine levelling is a must for a correct operation of the level detector and the inlet float valve water
level.
[Remark 5]:
To avoid airflow by-pass, double check that gap cover plates and fixing plates are well
installed and adjusted.
[Remark 6]:
Make sure that the correct amount of water (according to the technical specification) is
established in the balancing valves.
[Nota 7: Recirculated water systems]:
Be sure to remove the protection screen from the level
detector and the transport locking Silentblock placed under the pump.
[Nota 8: Recirculated water systems]:
If V ≥ 4 m/s, before the start-up, a rain gutter will be installed
to prevent the water in the basin from overcoming it.
Summary of Contents for HEF2 SERIES
