SH2000
82.150 Rev 100315
13
CONTROLS
5 CONTROLS
5.1 Machine Controls
5.2.1
This will activate the machine mechanism and
begin the run up to working temperature.
At the same time, controllers will show “
8888
”
immediately followed by current air temperature.
This indicates self-test procedure.
5.2.2
To check the current preset working
temperature in memory:
PRESS
1
PID 1
2
PID 2
3
PID 3 (See note)
4
PID 4 (See note)l
5
Emergency Stop
6
Column
7
Mode (Cool / OFF / Seal)
8
On Switch
5.2.3
Raising the machine to correct working temperature from cold takes 2 - 3 minutes,
depending on required temperature.
Do not attempt to run bags until required temperature is reached.
See “PID CONTROLER - AUTOTUNE” section.
Note:
If only 2 PIDs are installed, PID 3 and PID 4 will be
dummies and will not show a display.
For L-R configuration, PID numbers will read from
the other end.
8
5.2 Switch On
Press Start Button (8) and turn the
Cool/Off/Seal switch (7) to
SEAL
Right to Left Control Panel Layout
2
7
8
1
4
3
6
5
5
2
7
8
1
6
4
3
Left to Right Control Panel Layout
Summary of Contents for Saxon SH 2000
