SH2000
82.150 Rev 100315
19
6.6 PID Controller - Autotune
It is most important that the following sequence of instructions is
carried out in the CORRECT order.
If an error is made in the following sequence, e.g. if the
▲
or
▼
are not pressed
simultaneously, or are mis-used in any way, the Controller will move into another
non-related mode and display irrelevant data. If this occurs, STOP the sequence
IMMEDIATELY, and refer to the ‘
To Correct Any Setting Errors
’
instructions. (see
Section 6.7
)
6.6.1 PRESS AND HOLD
For approximately 5 seconds
6.6.2
THE DISPLAY WILL
ALTERNATE BETWEEN
tunE and one of these modes
and the modes will display
in this sequence
(
see below
)
6.6.3
Correct option required
for Autotune is
(alternately)
6.6.4
If anything other than
tunE
and
PArk
is
displayed
PRESS and
HOLD
6.6.5
PRESS momentarily to go UP the sequence
OR
6.6.6
PRESS momentarily to go DOWN the sequence
until
display reads:
IMPORTANT
SETTING UP
and
and
and
and
and
Summary of Contents for Saxon SH 2000
