SH2000
82.150 Rev 100315
25
6.12 Setting Heater Capsule Height
IMPORTANT:
BEFORE UNDERTAKING ANY MAINTENANCE PROCEDURE,
MACHINE MUST BE ISOLATED FROM MAINS SUPPLY.
WARNING:
THE HEATING CAPSULES MAY BE VERY HOT – ALLOW THEM TO
COOL BEFORE CARRYING OUT THIS PROCEDURE
6.12.1 Unscrew the Height Adjustment Screws under the centre of each Heater Capsule
(A) (access is under the Bottom Plates (C).
6.12.2 Place the Setting Tool (B) on the top surface of the Front Bottom Plate (C) as
shown with the “V” part touching the angles of both the Front Heater Capsules (A).
6.12.3 Keeping the Setting Tool in position, hold down one of the Heaters in contact with
the step on the Setting Tool and adjust the Height Adjustment Screw (under the
Bottom Plate) until it touches the Heater Capsule.
6.12.4 Repeat for the other Front Heater Capsule.
6.12.5 Repeat for the Rear Heater Capsules.
6.12.6 Remove the Setting Tool.
IMPORTANT NOTES:
The Earth Braids must be properly reconnected.
The Capsules must be left sufficiently loose to allow them to rise and fall with the
Adjustment Screws but without causing excessive air leaks.
A
B
C
SETTING UP
Summary of Contents for Saxon SH 2000
